Tuesday, December 27, 2016

The Last Hint of the Week...for the year


Underglaze From BigCeramicStore.com Tip #67
Confused by underglazes, that confusion may be caused by the fact that underglazes have changed throughout the years. [We have a few underglazes with the low fire glazes, but they are almost all for low fire, as the cone 6 & cone 10 glazes have been heavily used up this past year].

The original underglazes were quite similar to colored slips, made by adding pigments such as stains to watered down clay. Underglazes tend to be highly pigmented for strong color. They are desired for painting by many ceramists because they stay where you put them. In other words, the lines won't "flow" into each other like many glazes.

The original underglazes fire very dry or matt, so they were and are most often covered with a clear glaze [or a translucent glaze]. The underglazes are usually applied to wet clay or greenware. This way the "clay based" colors can shrink with the piece they are on and the glaze is more stable after bisquing and with subsequent firings with regular glazes.

In recent years glaze manufacturers have begun to make underglazes which can be applied to bisque. They do this by adding a more frit than clay. Frit contains silica which is one of the main ingredients in glaze. The silica causes the underglaze to "melt", effectively making it a little more like a glaze. This change allows you to apply the underglaze to bisque and/or to both greenware or bisque.

A few of these underglazes have enough "melt" that they are somewhat shiny and don't require a clear glaze. But you can put a clear glaze on any of them.

The next most common question involves when to apply the clear glaze (if you are applying one over the top of the underglaze.) If you are using underglaze on greenware, the most common method is to bisque the decorated greenware, then apply the clear glaze and fire again. One advantage of this is that you get a final chance to add more color/underglaze if you have an area that did not get enough coverage. Sometimes this problem doesn't show up until after a firing. Another advantage is that you won't risk messing up your design when you apply the clear glaze.

However, you can apply the clear glaze right over the top of the underglaze without a firing between. This is best done if you applied your underglaze to bisque, because greenware can absorb glaze and crack. There is also a risk that you can mess up the design by applying the clear. So a good approach is to sponge on the first coat of clear to help protect the underglaze. Then you can gently brush on your remaining coats. Often dipping the piece into clear glaze will not affect the underlying design either, but you should test as some underglazes do "dissolve" or "smudge" easier than others when a glaze is applied to it. Some clear glazes smudge the darker underglazes especially if the underglaze is not “bisqued-on” first.

Unlike glazes, underglaze colors can always be mixed together to create new colors. Also unlike glazes, the color when fired is similar to the color when wet (another reason why painters often prefer underglazes.)

However, a final consideration with underglazes has to do with firing temperatures. Technically all underglazes could go to the highest temperatures (such as Cone 10), but not all do. Although most Amaco Velvet series, all of the Coyote underglazes and a few others will go to cone 10, most others underglazes are fired lower [Always read the label carefully]. Remember, many underglazes are more like clay than glaze. But the colors do tend to burn out the hotter they are fired [yellows are notorious for burning out]. Some underglazes hold their colors better than others at the higher temperatures, so read the description on each color, and test at the temperatures you plan to fire to.

No comments:

Post a Comment